Publicidad
important notes
Please take a few minutes to read this user guide.
The KYOTO over-cot changer is designed for use with the KYOTO cot and KYOTO
chest only.
Provided it is used with and securely attached to the correctly assembled cot or
chest this changer conforms to BSEN 12221-1: 2000 (Safety standard for changers).
Unpack your changer carefully onto a soft level surface, such as a carpeted floor.
Do not discard any packaging until you are sure that you have all the parts.
A Changing mat is recommended for use with this changer, with maximum
dimensions of 75cm x 45cm. Make sure it is placed squarely on the tray, and evenly
between the barriers.
parts check list
fig 1.1
Over-cot changer
("Velcro" strap attached)
attachment to the Kyoto cot
fig 2
A
B
C
D
Make sure there is at least 70mm between the cot and any wall or other piece
of furniture. With the strap (A) towards you, lower the changer onto the cot
sides, ensuring that the battens (B) on the underside sit outside both cot sides.
The rear length of strap (C) must be inside the cot and the front length (A) must
be outside. Bring C forward between two of the side slats (D) and wrap A back
over it to secure the changer.
ENSURE THE VELCRO STRAP IS TIGHTLY FASTENED TO THE COT BEFORE USE.
1
fig 1.2
Fittings (Bolt, washer, attachment
ring and wing nut).
B
B
D
C
D
A
Publicidad
