Controls And Operational Features - Helvi FOX 185 FLEX-LINE Manual De Uso

CONTROLS AND OPERATIONAL FEATURES

Figure 1
4
8
11
1. Power switch indicator: This green LED lights when the welding machine is ON and is ready to work.
A steady green LED indicates the welder is connected to and recognizes a 230V volt power supply.
A blinking green LED indicates that the welder is connected to and recognizes a 115V volt power
supply. In the event of an overvoltage supply the green LED blinks and the red LED (3) is ON.
2. Thermal overload indicator: If the yellow LED is ON it indicates that the welder has overheated and
the machine has automatically shut down. This may be a result of having exceeded the welders duty
cycle or that normal cooling air flow has been interrupted. Check to confirm that the cooling fan is
running and that air flow is not blocked. Do not turn off the welder as this will stop the cooling fan.
When the welder has cooled sufficiently the yellow LED will go out and the welder is ready to weld.
3. Alarm indicator: This red LED lights when there is a working abnormality such as an over voltage
supply.
4. Left Display: During welding it displays the actual value of the output current (AMP).
When the machine is not welding, (no load), the display shows the value of the parameter selected
with the Left Knob (8):
a. In STICK and TIG mode it shows the selected current value.
b. In MIG MANUAL mode the display shows the selected wire speed in m/min.
c. In MIG SYNERGIC mode the display shows wire speed balance; possible variation is +/-40%
on the base value adjusted by default ( "0" on the display, central position).
5. Right Display: during welding it displays the actual arc voltage.
When the machine is not welding (no load) it displays the value of the parameter adjusted with the
Right Knob (7):
a. in STICK mode it displays the Hot Start over-current value expressed as a percentage of the
base welding current selected with the left knob (8). The over current value is variable from 0 to 50%
of the base current. Maximum Hot start value of 50% can be adjusted up to 120Amp of welding
current. On the display the value of Hot Start is shown as "H" and the value of the over current in %.
b. In TIG Mode the display is not active.
c. In MIG MANUAL it displays the selected arc voltage from 12V to 26V.
d. In MIG SYNERGIC it displays the thickness of the material to be welded expressed in mm.
1 2 3 5
-ENGLISH-
Figure 2
6
12
7
13
9
10
14
21