What To Do If - AEG Electrolux 67670M-MN Manual Del Usuario

What to do if ...

Problem
The cooking zones are not
functioning.
The residual heat indicator
is not displaying anything
flashes
is lit
If you are unable to remedy the problem by following the above
suggestions, please contact your dealer or the Customer Care De-
partment.
40
All manuals and user guides at all-guides.com
Possible cause
The combination appliance
is not switched on.
The desired heat setting is
not set.
The fuse in the house's
electrical wiring (fuse box)
has been tripped.
Combination appliance
was connected to the elec-
tricity supply when the
cooking surface was in-
stalled.
The cooking zone was only
on for a short time and is
therefore not hot
Unsuitable cookware
No cookware on the cook-
ing zone
The diameter of the bot-
tom of the cookware is too
small for the cooking zone
Overheating protection for
the cooking zone has been
triggered
When switching on the
combination appliance, the
ring switch was not in the
Off position
Cooking zone without
cookware for longer than
two minutes
Remedy
Switch on the appliance.
Set the heat setting.
Check the fuse.
If the fuses trip a number
of times, please call an au-
thorised electrician.
Take fuse out and re-insert
(fuse box), or switch off
and on again
If the cooking zone is sup-
posed to be hot, call the
Customer Service Depart-
ment.
Use suitable cookware
Place cookware on the
cooking zone
Move onto a smaller cook-
ing zone
Use suitable cookware
Switch off cooking zone
Switch cooking zone on
again
Switch off cooking zone,
place cookware on cook-
ing zone, switch cooking
zone on