Description - Hilti WSC 70 Manual De Instrucciones

Obligation signs
Wear eye Wear a hard
protection hat
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Rated speed Revolutions
under no per minute
load

2 Description

2.1 Use of the product as directed
The power tool is a hand-guided circular saw.
The power tool is designed for sawing wood or wood-like materials, plastics, drywall panel (plasterboard), gypsum
fiberboard and composite materials with a thickness of up to 55 or 70 mm (depending on model) and for bevel cuts at
angles between 0 ° and 50 °.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
The use of saw blades not in compliance with the given specification (e.g. diameter, speed of rotation, thickness) or
the use of cutting and grinding discs or blades made from high-alloy steel (HSS steel) is not permissible.
Sawing metals is not permissible.
Do not use the power tool to cut tree branches or logs.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Modification of the power tool or tampering with its parts is not permissible.
Wear ear Wear
protection protective
gloves
Volts Alternating
current
Diameter Saw blade
Location of identification data on the power tool
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Serial no.:
en
15