bort medical 215 880 Instrucciones De Uso página 13

6
Then, shape the back plate to the contours of the spine. Ensure finger width
distance (approx. 1.5 cm) of the course of the splint in the lumbar spine region
and a little space between the back plate and the body on the upper (cranial) edge to
the body (approx. 2 cm). This supports the straightening of the patient and lordosis
reduction of the lumbar spine.
7
Then, shape the reinforcement module to the contours of the back plate just
adapted. Pay attention to the position markings which define the reinforcement
plate region. Pay attention to good form fit for both modules. Then connect the back plate
to the reinforcement module using the 4 clasps previously removed. They are spread apart
and respectively attached to the uppermost and lowest reinforcement plate openings. The
clasp is properly closed when you hear a click. Finally, check the connection. Then, push
the back element back into the brace and tighten the Velcro protector.
8
The guide can be configured dynamically or as stable in the shoulder height
region. To realise a stable/non-elastic setting, the overlay which can be attached
using Velcro must bridge the elastic restraint segment in the shoulder height region. For
secure fixing of the overlay, pay attention to its guidance through the rucksack loop and
fix the end on the base material.
9
Place the brace on the patient, it can be positioned by the patient like a
rucksack, then close the ventral plate. The lower edge must be at the height of
the gluteal fold. The front ventral plate should be positioned at the height of the pubic
bone and not restrict hip flexion.
10/10.1
Start with the harnesses on the hip, always tighten the straps on both sides in sync.
After completion, tighten the crocodile clasp ends and close the harness under slight
tension. Pay attention to an appropriate length.
11
Next, adjust the combined torso and shoulder straps and proceed as described
above. Before finally shortening the straps, ensure that there is a gap of
Then set the brace strap lengths. Remove the crocodile clasp
ends of the strap and shorten the strap lengths accordingly.
EN
13