Publicidad
Step 13
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (N) and lay it over your unit.
Make equal margins along all four edges of the BACK (N).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (N) to the BRACE (L). Use four 1/2" PAN
å
HEAD SCREWS (14).
Fasten the BACK (N) to your unit using the NAILS (9).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the SHELVES (F and O).
These holes must line up
over the SHELVES (F and O).
Page 18
N
www.sauder.com/service
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
NAIL
(51 used in this step)
14
1/2" PAN HEAD SCREW
(4 used in this step)
8
9
430083
Publicidad
