Publicidad
Step 16
Before fastening the DOORS to your unit, be sure the
å
mounting screw is against the outer end of the slot as
shown in the right diagram. If it isn't, loosen the adjusting
screw and mounting screw to slide it against the end of
the slot. Then tighten the mounting screw.
Fasten the LEFT DOOR (H) to the LEFT END (A). Use the
å
SCREWS in the HINGES.
Fasten the CENTER DOOR (K) to the UPRIGHT (C). Use
å
the SCREWS in the HINGES.
Fasten the RIGHT DOOR (J) to the RIGHT END (B). Use
å
the SCREWS in the HINGES.
Fasten the PULLS (8) to the DOORS (H, J, and K). Use six
å
5/8" MACHINE SCREWS (13).
430083
A
H
www.sauder.com/service
Slot
Mounting
screw
Adjusting
screw
B
C
K
8
17
Hinge
8
J
5/8" MACHINE HEAD SCREW
(6 used in this step)
Page 21
13
Publicidad
