Consumables; Faults - Kärcher WPC 2500 FW-AM Manual De Instrucciones

Consumables

Description
RM 852 Sterilisation
agent
Vitec 3000 Hardness
stabiliser
Filter insert for fine filter,
5 µm for WPC 2500...
Filter insert for fine filter,
5 µm for WPC 5000...,
WPC 10000...
The LEDs on the operating panel and
on the display will show the interrup-
tions in the RO plant.
Note
If there is an interruption, the plant gets
switched off automatically and the
Description /
Display
LED fault
regeneration Automatic flush is active
tank full
Display Conductivity
exceeded
Hard water
Pressure in-
terruption
Dosing pump transports too
much or too little
Dosing pump does not
transport.
Order No.
6.414-
838.0
6.414-
812.0
Interruptions in the RO plant
drinking water production is interrupt-
ed. If the problem cannot be rectified,
switch off the plant and inform Kärcher
Customer Service.
If the plant does not start automati-
cally, pull the plug out of the socket,
Dosing container is empty
Sensor signal missing
Drinking water tank is full.
Float switch in drinking water tank is defec-
tive.
Guide value of drinking water is too high.
Dosing container is empty
Pressure of raw water is too low.
Interruptions in the dosing stations
Dosing frequency is displaced.
Plant is not switched on.
Dosing pump is not deaerated.

Faults

Fill dosing container and then acknowledge the
fault.
Inform Customer Service.
Nothing needs to be done; the plant will start au-
tomatically
Nothing needs to be done; the plant will start au-
tomatically
Inform Customer Service.
Inform Customer Service.
Fill dosing container and then acknowledge the
fault.
Check raw water supply:
Installation in the building
–
Advance pressure pump
–
Fine filter status (see "Maintenance tasks"
–
Set the dosing frequency.
Switch on plant.
Bleed dosing pump.
wait 5 seconds and replace the
plug. The controls will get reset.
Rectify other faults according to the
details provided in the following ta-
bles.
9
English