Handle Height - Snapper 7800709 Manual Para El Operador

Adjusting the Handle Height
1. Remove the wingnuts (A, Figure 4), washers (not
shown), and bolts (B) from the right and left handle
brackets (C).
NOTE: Do not remove the lower set of handle hard-
ware (D).
2. Adjust the handle to a higher or lower height
adjustment hole (A, Figure 5).
3. Reinstall the bolts, washers and wingnuts removed
in Step 1.
en
B
D
Figure 4: Removing the handle adjustment hardware
A
Figure 5: Height adjustment holes
(Components removed for clarity)
Assembly
A
C
9