Something Not Working; Possible Cause - Electrolux EWN 12791 W Manual Del Usuario

32 electrolux something not working

Something not working

Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service
Centre, please carry out the checks listed below.
During machine operation it is possible that it is possible that the
pilot light flashes, one of the following alarm codes appears on the display and the
buzzer sounds to indicate that the machine is not working:
E10
: problem with the water supply
●
E20
: problem with water draining
●
E40
: door open.
●
Once the problem has been eliminated, press the
programme. If after all checks, the problem persists, contact your local Service Centre.
Malfunction
The washing machine does
not start:
The machine fills then
empties immediately:
All manuals and user guides at all-guides.com

Possible cause

The door has not been
●
(E40)
closed. .
The plug is not properly
●
inserted in the power
socket.
There is no power at the
●
socket.
The main fuse has blown.
●
The selector dial is not
●
correctly positioned and the
Start/Pause button has not
been depressed.
The delay start has been
●
selected.
The end of the drain hose is
●
too low.
red
Start/Pause button to restart the
Solution
Close firmly the door.
●
Insert the plug into the
●
power socket.
Please check your domestic
●
electrical installation.
Replace the fuse.
●
Please turn the selector dial
●
and press the Start/Pause
button again.
If the laundry are to be
●
washed immediately, cancel
the delay start.
Refer to relevant paragraph
●
in "water drainage" section.
Start/Pause