Something Not Working - Electrolux EWF 14118 Folleto De Instrucciones

Something not working?

Problems which you can resolve yourself.
During machine operation it is possible that one of the following messages appear on the display:
- Problem with the water supply: "No incoming water. Check tap & hose"
- Problem with water draining "No drain. Check drain hose /filter"
- Door open: "Door not closed. Please check"
Once the problem has been eliminated, press the Start/Add clothes button
all checks, the problem persists, contact your local Service Centre.
Problem
• The machine does not start up:
• The machine does not fill:
• The machine fills then empties
immediately:
• The machine does not empty
and/or does not spin:
• There is water on the floor:
1-25 ES Mac64.indd 24 1-25 ES Mac64.indd 24
All manuals and user guides at all-guides.com
• The door is not firmly closed.
• The machine is not plugged in or there is no power
• The main fuse has blown.
• The Start/ Add Clothes button
• The DELAY START option has been selected.
• The programme selector dial is not positioned.
• The water tap is closed.
• The inlet hose is squashed or kinked.
• The filter in the inlet hose is blocked.
• The door is not properly closed.
• The end of the drain hose is too low. Refer to
• The drain hose is squashed or kinked.
• The RINSE HOLD option
• The laundry is not evenly distributed in the drum.
• The drain pump is clogged.
• Too much detergent or unsuitable detergent
• Check whether there are any leaks from one of the
• The drain hose is damaged.
• The cap on the emergency emptying hose has not
24
24
to restart the programme. If after
Possible cause
( "Door not closed. Please check")
at the socket.
pressed.
("No incoming water. Check tap & hose")
("No incoming water. Check tap & hose")
("No incoming water. Check tap & hose")
("Door not closed. Please check")
relevant paragraph in "water drainage" section.
("No drain. Check drain hose /filter")
, NIGHT CYCLE
or NO SPIN «O» has been selected.
("No drain. Check drain hose /filter")
(creates too much foam) has been used.
inlet hose fittings. It is not always easy to see this
as the water runs down the hose; check to see if it
is damp.
been replaced after cleaning the pump.
has not been
3/4/06 12:45:50 AM 3/4/06 12:45:50 AM