Blackstar Amplification SILVERLINE STANDARD El Manual Del Propietario página 9

Rear Panel
28. Mains Input
The supplied detachable mains lead is connected here. The lead should only
be connected to a power outlet that is compatible with the voltage, power and
frequency requirements stated on the rear panel. If in doubt, seek advice from a
qualified technician.
Programmability
Storing Patches
To store the current sound as a patch:
1. Press and hold any of the four Channel switches for one second. All four
Channel LEDs will begin to flash.
2. Press the Bank switch to toggle through the three banks (green, orange, red)
to choose the store location.
3. Press any of the four Channel switches once to store the patch in the chosen
location.
The LED corresponding to the chosen store location will illuminate and the new
patch will be active.
Green bank = Patches 1-4
Orange bank = Patches 5-8
Red bank = Patches 9-12
The amplifier controls can be used to edit the patch at any stage of the store
process.
Press the Manual switch at any stage to cancel the store process and return the
amplifier to the last state.
Storing a patch will overwrite any previous patch in that location.
Patches can also be stored via Blackstar's INSIDER software or a connected
Blackstar FS-10 footcontroller.
Recalling Patches
Press any Channel switch to load that patch.
Pressing the Bank switch will cycle through the three banks – green-orange-red.
The Channel will be preserved, therefore the corresponding patch within the current
Bank will be loaded when scrolling through the Banks.
Alternatively, patches can be recalled via Blackstar's INSIDER software or any
connected footcontroller.
16
All manuals and user guides at all-guides.com
Factory Patches Table
Green Bank - Live Rig 1
Channel
CH1
CH2
CH3
CH4
Orange Bank - Live Rig 2
Channel
CH1
CH2
CH3
CH4
Red Bank - Live Rig 3
Channel
CH1
CH2
CH3
CH4
Patch Name Voice Response Effect(s)
LR1 - Clean Clean Warm 6L6 Spring Reverb
LR1 - Crunch Crunch EL34 Hall Reverb
LR1- Rhythm Super Crunch EL34 Tape Delay, Hall
Reverb
LR1 - Lead OD 1 KT88 Analogue Delay
Patch Name Voice Response Effect(s)
LR2 - Clean Clean Warm 6V6 Plate Reverb
LR2 - Crunch Clean Bright KT66 Hall Reverb
LR2- Rhythm OD 1 EL84 Hall Reverb
LR2 - Lead Super Crunch 6L6 Analogue Delay,
Hall Reverb
Patch Name Voice Response Effect(s)
LR3 - Clean Clean Bright KT88 Flanger,
Analogue Delay,
Hall Reverb
LR3 - Crunch Crunch EL84 Plate Reverb
LR3- Rhythm Super Crunch 6V6 Analogue Delay,
Plate Reverb
LR3 - Lead OD 2 KT88 Analogue Delay,
Hall Reverb
Description
US clean with high
headroom, perfect as a
platform for your pedals
British low gain crunch with
natural reverb
British classic rock crunch,
ideal for guitars with
humbuckers
Full sounding dynamic lead
Description
US low wattage 'sag' clean
tone with natural reverb
Rhythm tone with breakup,
great for a classic Indie
sound
Smooth drive with a slight
mid boost
Balanced lead tone with
delay, perfect for solos
Description
Modulated clean tone,
ideal for appegiated
chords
Dynamic crunch, perfect
for big open chords
Compressed crunch, great
for rhythm playing
Smooth high gain tone,
ideal for legato whilst
maintaining note definition
17