Technical Specification; Firmware Update - Blackstar Amplification SILVERLINE STANDARD El Manual Del Propietario

Ocultar thumbs

Contenido

página de 57

/ 57
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

USB Audio

Standard device drivers are used to connect the amplifier to a PC or Mac, therefore

no additional device drivers are required. If your computer's audio latency is found

to be too high a generic ASIO driver can be downloaded and associated with your

amplifier, for example ASIO4ALL – www.asio4all.com. For a guide on low-latency

USB recording visit:

www.blackstaramps.com/usbrecording

NOTE: Always connect the amplifier via a main USB port, often found on the rear

of the computer.

The output of the audio over USB can be changed via the Blackstar INSIDER

software, and can be one of the following:

 Speaker emulated stereo effected audio channels

 2 x mono audio channels

- Left – effected amplifier signal

- Right – unprocessed guitar signal

 Reamping Mode

Reamping

The amplifier can be switched into Reamping Mode via Blackstar INSIDER software.

This is a non-storable setting and will be switched off either when the USB cable is

removed, or when the amplifier power is switched off.

When activated, Reamping Mode allows the amplifier to accept a pre-recorded, dry

guitar signal via USB and return a fully processed audio signal. This return signal can

then be captured using recording software on the connected PC or Mac.

Firmware Update

Firmware updates are initiated via the Blackstar INSIDER software. A new version

of the Blackstar INSIDER software will be released whenever an update is available.

Each update will take approximately 60-120 seconds.

When the amplifier is connected (via USB) to a version of the Blackstar INSIDER

software containing newer firmware, a message will be displayed, prompting you to

install the latest files. Whilst updating, the amplifier controls will be unresponsive. The

Tap LED will flash to indicate data activity during the update process.

The amplifier power should not be switched off during a firmware update. If the

amplifier is switched off during an update, the controls will be unresponsive after the

power is reapplied and the amplifier will produce no sound. The Tap LED will flash

to indicate that the amplifier contains no valid firmware.

The amplifier must be connected to the Blackstar INSIDER software to reinstall

valid firmware. The update process will start automatically if the Blackstar INSIDER

software detects that the amplifier is in this state.

All manuals and user guides at all-guides.com