Tabla de contenido
Publicidad
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - showerhead
Flow rate - handshower
Flow rate - tub filler
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly be-
fore beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
• The installation dimensions shown in this
installation instruction are ideal for people of
approximately 6' in height. The dimensions can
be changed if required. In this case, the minimum
ceiling height of 86⅜" from the standing surface,
and all other measurements, must be changed.
• The installer must ensure that the entire area of
the wall to which the mounting plate is to be
mounted, is flat (no protruding grout joints or
tiles). He should also make sure that the wall is
strong enough to support the showerpipe.
This unit meets or exceeds the following:
•
ASME A112.18.1
•
CSA B125.1
•
Listed by IAPMO for use in the US
and Canada
2
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
2.0 GPM max.
1.85 GPM max.
5.3 GPM@ 44 PSI
*Please know and follow all applicable local plumbing
codes when setting the temperature on the water heater.
• The enclosed screws and anchors are suitable for
a solid surface wall. If installing in a fiberglass or
acrylic shower unit, install header boards at the
mounting points.
• This showerpipe requires showerpipe rough
16181181(not included).
• This showerpipe is for use with shower heads
rated at 1.7 GPM (6.4 l/min) or higher.
• To prevent scald injury, the maximum output tem-
perature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum out-
put temperature can be no higher than 112° F.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicidad
Tabla de contenido
