Lacor Mix & Go 69382 Instrucciones De Uso Y Mantenimiento página 36

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 3
4.- Allow a minimum of 12" (30 cm) clearance along the sides.
Allow a clearance of 20" (50 cm) along the front and rear
discharge to endure proper operation and safety.
5.- To prevent any injury or damage do not pull unit by power
cord.
6.- To prevent any injury, discontinue use if power cord is frayed
or worn.
1.- Locate the unit at the proper counter height, in an area that is
convenient for use. The location should be level to prevent the
unit or its contents from accidentally falling, and strong
enough to support the weight of the unit.
2.- Do not place anything on top of the Personal blender fresh
& go; doing so could damage Personal blender Mix & Go or
subject personnel to possible injury.
3.- When setting up the unit for operation, make sure power to the
unit is off. Failure to do so could result in personal injury.
4.- To avoid damaging the Personal blender Mix & Go or causing
personal injury, always switch on the blender with a product
inside the bowl.
5.- Unit is not weatherproof. For safe and proper operation locate
the unit indoors where the ambient air temperature is a
minimum of 70ºF (21ºC) and a maximum of 85ºF (29ºC).
6.- Do not locate the Personal blender Mix & Go in an area
subject to excessive temperature or grease from grills, fryers,
etc. Excessive temperature could cause damage to the unit.
7.- Do not place Personal blender Mix & Go in an area that
restrict air flow around the front or rear of the unit.
8.- Some exterior surfaces on the unit will get hot. Use caution
when touching these areas to avoid injury.
36
CAUTIONS
!

Publicidad

Tabla de contenido
loading

Tabla de contenido