GE PTD60GBPRDG Instrucciones De Instalación página 17

REVERSING THE DOOR (OPTIONAL)
1
Open the door approximately 130 degrees. With a
putty knife, remove the 4 plastic caps located
along the left side of the front panel and set them
aside.
2
Remove the bottom screw from each hinge (right
side) and partially insert them into each top hinge
hole on the left side.
NOTE: All 4 front panel hinge screws will now
be in the top hinge holes - 2 on the left and 2 on the
right.
3
Loosen each top hinge screw on right side.
Remove the door and place it on a protective flat
surface to avoid any damage.
Loosen each
top hinge screw
on right side
Installation Instructions
Plastic Cap (4)
Left side of
front panel
4
Remove both the blind plate and the strike plate and
install them in the opposite positions.
Blind
plate
5
Remove the 2 hinge plastic caps and 4 hinge screws.
Hinge
screws
Hinge
Plastic
Caps
6
Remove the 8 inside screws. Lift the inner door
upwards using a flat blade screwdriver. Remove the
2 door hinges.
Inside
screws
Door
Hinges
17
Inner door
Outer door
Strike
plate
Inside
screws