REVERSING THE DOOR (OPTIONAL) (cont.)
7
Remove and swap the two plastic caps onto the
opposite side.
Install plastic
caps from
opposite side
here
8
Rotate the outer door 180°. Place hinges into
position, making sure you mount the hinges on the
side opposite the pocket. Mount the inner door
back into the outer door frame and secure with
screws removed in step 6. Screw the door hinges
in and insert the hinge caps.
Inside
screws
Inner door
Outer door
Installation Instructions
Plastic
Caps
Hinge
Plastic
Caps
Hinge
screws
Hinge
Inside
screws
9
Mount the assembled door on the 2 upper left side
hinge screws installed in step 2. Move the hinge
screws loosened in step 2 into the lower left side
screw holes and firmly tighten all 4 screws.
Door
10
Install the 4 plastic caps removed in step 1 into
the 4 right side front panel holes.
Plastic Cap (4)
Right side of
front panel
NOTE: To return the door to the original setup, follow
these instructions, swapping "left" and "right".
When you finish
Plug the dryer back into
its electrical outlet.
18
Hang door and
tighten screws