Setting The Channel; Displaying The Outdoor Temperature; Displaying The Temperature Trend (Outdoor); Displaying The Indoor Temperature - Auriol Z31092 Instrucciones De Utilización Y De Seguridad

All manuals and user guides at all-guides.com
0HR = present barometric pressure
– 1HR = barometric pressure an hour earlier
– 2HR = barometric pressure two hours
earlier, etc.
Press and hold down the "+" / °C / °F button
28 for about 3 seconds to switch between
displaying the barometric pressure units in
inHg or mb / hPa.

Setting the channel

To do this open the battery compartment on
the back of the outdoor sensor and take it off.
Set the channel by means of the Channel
selection switch 39 .
Press the channel button for approx. 3
26
seconds until a signal is sounded. The wea-
ther station has now received one signal.
Press the TX button 42 to transmit the measured
temperature to the weather station manually.
Then close the battery compartment
Displaying the outdoor
temperature
Press the Channel button 26 to display the
outdoor temperature of each outdoor sensor.
– Press the Channel button 1 x to display
26
channel 1.
– Press the Channel button 26 2 x to display
channel 2.
– Press the Channel button 26 3 x to display
channel 3.
– Press the Channel button 4 x to display
26
all the channels one after the other in a loop.
Only the outdoor sensors which can be
addressed are displayed.
Press and hold down the Channel button
to remove unused channels. If a further out-
door sensor and channel are added later,
the weather station will receive the signal
automatically. Alternatively, you can also
transmit the initial signal from the outdoor
sensor manually by pressing the TX button
Displaying the temperature
trend (outdoor)
After successfully connecting with the outdoor
sensor, the weather station can display the
Temperature trend .
21
You may see the following displays:
= The outdoor temperature is rising.
= The outdoor temperature is remaining
constant.
= The outdoor temperature is falling.
Displaying the indoor
temperature
The current Indoor temperature
the LC display.
Displaying temperatures
in °C / °F
Note: °C is the legally required temperature unit.
Note: The weather station is supplied in the
default setting of °Celsius.
Press the "+" / °C / °F button
between the Celsius and Fahrenheit tempera-
ture scales.
Displaying the air humidity
(indoor)
.
40
The current air humidity
display. The Comfort indicator
air humidity in three categories.
The following categories are available:
"Dry" = Air humidity
"Comfort" = Air humidity
indoor temperature
24 °C–27.9 °C
"Wet" = Air humidity
Displaying the maximum /
minimum temperature /
humidity
The minimum / maximum temperature / humidity is
26
measured for the first time after the batteries have
been inserted and stored in the weather station.
Press the "–" / MAX / MIN button
The maximum indoor
42 . perature 24 measured and the maximum
humidity 5 measured are shown.
Press the "–" / MAX / MIN button
briefly. The minimum indoor
temperature 24 measured and the minimum
humidity 5 measured are shown.
Press the "–" / MAX / MIN button
briefly to return to the current values.
Note: If no button is pressed within 5 seconds,
the displays automatically return to the
standard display.
Hold the "–" / MAX / MIN button
for approx. 3 seconds in order to delete the
stored maximum and minimum values when
you hear a beep sound. The values measured
from the time of deletion of the old values
until the next time the memory is called up
can be called up again.
Operation
is shown in
3
28 to switch
5 is shown in the LC
4 displays the
5 < 45 %
45–75 %,
5
3
5 > 75 %
briefly.
29
and outdoor tem-
3
again
29
and outdoor
3
29 again
down
29
GB/MT 41