Power Supply; Setting Into Operation - IMG STAGELINE TXS-875HSE Manual De Instrucciones

In other countries, it is necessary to apply for a
corresponding approval . Prior to operating the
transmitter outside Germany, please contact
the MONACOR subsidiary or the correspond-
ing authorities of the respective country . Links
to the national authorities can be found via the
following Internet address:
www .cept .org
t ECC
t Topics
t Other spectrum topics: SRD Regulations
and indicative list of equipment sub-classes
t EFIS and National Frequency Tables

4 Power supply

•
Insert only batteries of the same type and
always replace all batteries .
•
If the unit is not used for a longer period
(e . g . more than a week), remove the bat-
teries . Thus, the unit will not be damaged in
case of battery leakage .
1) Press down the two latching buttons (8) on
the sides of the transmitter . The control part
will unlock and can be moved in its casing .
Slide the control part downwards until it
locks into place again . This will allow access
to the battery compartment (11) on the rear
side of the transmitter (see fig . 3) .
2) Insert two 1 .5 V batteries of size AA (R6) into
the battery compartment, with the positive
and negative connections as indicated in the
compartment .
3) Unlock the control part, slide it back to its
previous position until it locks into place .
Never put discharged batteries in the
household waste . To protect the envi-
ronment, always take them to a special
waste disposal, e . g . collection container
at your retailer .
8

5 Setting into Operation

1) Connect a headband microphone or tie-
clip microphone (e . g . the headband micro-
phone HSE-110 or the tie-clip microphone
ECM-402L from MONACOR) to the mini XLR
jack (4) .
2) To switch on, set the power switch (2) to ON .
The display (3) indicates the transmitting fre-
quency adjusted and a battery symbol which
indicates the current charging status of the
batteries in several steps:
full
3) Press down the latching buttons (8) on the
sides of the transmitter and slide the control
part upwards in its casing until it locks into
place (see fig . 1) .
4) Adjust the radio frequency for the trans-
mitter see chapter 5 .1 . Switch on the
☞
receiver and set it to the same frequency
see operating instructions of the receiver .
☞
Switch on the audio unit (mixer or ampli-
fier) connected to the receiver .
5) Speak / sing into the microphone . The vol-
ume level can be readjusted by changing
the sensitivity via the control GAIN (10) . Use
the supplied adjusting key for turning the
control .
Adjust the transmitter to an optimum
level . If the level is too high, the transmit-
ter will dis tort; in this case, turn back the
control (if required, even to the left stop) . If
the level is too low, a poor signal-noise ratio
will result; in this case, advance the control
correspond ingly .
6) The transmitter can be locked to prevent ac-
cidental change of frequency or accidental
switching off
☞
7) After all adjustments have been made, un-
lock the control part and slide it back to its
previous position until it locks into place .
8) Use the clip (9) to attach the transmitter to
your clothing, e . g . belt or waistband .
To modify the position of the trans-
mitter on your clothing, the clip can also be
discharged
chapter 5 .2 .