Stand By; Safety Systems - Zummo Z1 Manual Del Usuario

8

STAND BY

The machine has a stand-by power-saving system which is activated automatically after 5 minutes. When
the machine is on stand-by, the display light goes out and all the icons except the one for the machine are
disabled.
To exit this situation, press any of the three buttons on the plate.
9

SAFETY SYSTEMS

The machine has various safety systems:
1 If the cover is not fitted properly, the display shows the Error message with the area of the cover
flashing.
2 If the Juicetray is not assembled or improperly assembled, the machine will not operate and the
display will show Error message. The tray flashes as a shadow.
3 If the upper protective device is not fitted properly the machine will not work and the display
shows the Error message with the area of the protective device flashing.
4 If the bin is not fitted properly, the machine will not work and the display will show the Error
message along with the area of the filter tray flashing.
5 If for any reason the machine gets blocked during operation, after a few seconds the motor will
stop automatically and the display will show Error message with a faulty flashing icon, until the
cause of the blockage is removed.
6 Thanks to a thermal protection system in the motor, in the event of overheating the machine will
stop and the display will show Error message and a thermometer icon. In this case, please wait
around 10 minutes to allow the motor temperature to decrease.
disappear. Please check that the ventilation gratings are not obstructed.
7 If there is no message on the display, it means there is no power supply. Check that the power
switch is on and that the plug fuse is not burnt out (Fig.11).
16
The error message will