Control Unit - V2 KIT ECOGOLD230 Manual De Instrucciones

CONTROL UNIT

The new programmable control unit PRGS433PPV2E /
PRGSPPV2127E (for Personal Pass radio system kits) is
used in automated systems for sliding gates, and gua-
rantees a fast and easy installation.
Programming the operation logic and the working sche-
dule is extremely easy and prompt; besides, the five
control LEDs on the unit allow a continuous monitoring
of the input statuses. Thanks to an automatic electro-
nic check, outputs toggle at zero current, with no scintil-
lation effect on the relays.
This control unit allows to store up to 83 different
codes, delete all the codes in the memory and input
new ones afterwards.
WIRELESS STORAGE OF CODES
To correctly store a code, a minimum distance of 1.5
meters should be observed between the transmitter
and the receiver antenna. To wireless-store the required
codes, proceed as follows:
• Press and hold button PROG. RX until LED L1 lights up.
• Press and hold transmitter button until LED L1
goes out: the LED goes out for about half a second,
thus showing a correct storing of the code; imme
diately, the LED starts flashing a number of times
according to the memory zone just occupied.
When the flashing stops, the system is ready for use.
IMPORTANT: each stored code is associated to the
START command only.
TOTAL DELETION OF THE CODES IN THE
MEMORY
Strictly follow these steps:
• Disconnect the unit power line.
• Press and hold programming button PROG. RX.
• At the same time, reconnect the power line: when
programming LED L1 flashes, release button
PROG. RX.
Now the 83 zones of memory are empty and available
for a new programming process.
A partial deletion of codes is only possible with
programming device PROG2.
ATTEMPT TO STORE A CODE ALREADY
PRESENT IN THE MEMORY
If an attempt is made to store a code already present
in the memory, programming LED L1 performs a num-
ber of flashes that equals the one concerning the zone
of memory already occupied. Differently from the nor-
mal code programming function, the LED flashes with a
higher frequency and the last flash has duration of
about 2 seconds.
The user can take advantage of such a function to iden-
tify, at any time, the zone of memory where every single
transmitter accessing the system has been stored.
USING THE PROGRAMMER
The storage of remote control codes and the handling
of the receiver memory contents can be performed with
programming device PROG2. Refer to PROG2 Operation
Manual for a correct use of the programming device.
All manuals and user guides at all-guides.com
14
ADJUSTING THE POWER AND THE
OPERATION SCHEDULE
The power and the operation schedule can be adjusted
by means of three potentiometers located on the
control unit:
POWER: motor power.
T. WORK: time of working.
T.PAU : time of pausing (only if the CONTROL UNIT is
programmed to close automatically).
STATUS INDICATORS OF THE UNIT INPUTS
LED FUNCTION
L1 Programming
L2 START: lights up when a pulse is received at the
START input terminal
L3 STOP: goes out when a pulse is received at the
STOP input terminal
L4 PHOTOCELL: goes out when a pulse is received
at the PHOTO input terminal
L5 OPENING LIMIT SWITCH: goes out when a pulse is
received at the opening limit switch input terminal
L6 CLOSING LIMIT SWITCH: goes out when a pulse is
received at the closing limit switch input terminal.