Troubleshooting Guide; Technical Service - Heath Zenith Secure Home SH-5412 Manual De Instrucciones

SYMPTOM POSSIBLE CAUSE
Lights will not come 1. Light switch is turned off.
on.
2. F l o o d l i g h t i s l o o s e o r
burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect (re-
check after dark).
5. Incorrect circuit wiring, if this is a
new installation.
6. Re-aim the sensor to cover de-
sired area.
Lights come on 1. Light Control may be installed in
in daylight.
a relatively dark location.
2. Light Control is in Test.
(Set control switch to an
ON-TIME position).
Lights come on 1. Light Control may be sensing
for no apparent
small animals or automobile traf-
reason. fic (re-aim sensor).
2. R a n g e i s s e t t o o h i g h .
(Reduce Range).
Please call 1-800-858-8501 for assistance before returning product to store.
If you experience a problem, follow this guide. You may also want to visit our Web site at: www.desatech.com. If the
problem persists, call* for assistance at 1-800-858-8501, 7:30 AM to 4:30 PM CST (M-F). You may also write* to:
DESA Specialty Products
P.O. Box 90004, Bowling Green, KY 42102-9004
ATTN: Technical Service Specialty Products
* If contacting Technical Service, please have the following information available: Model Number, Date of Pur-
chase, and Place of Purchase.
No Service Parts Available for this Product
This is a "Limited Warranty" which gives you specific legal rights. You may also have other rights which vary from state
to state or province to province.
For a period of ten years from the date of purchase, any malfunction caused by factory defective parts or workmanship
will be corrected at no charge to you.
Not Covered - Repair service, adjustment and calibration due to misuse, abuse or negligence, light bulbs, batteries,
and other expendable items are not covered by this warranty. Unauthorized service or modification of the product or of
any furnished component will void this warranty in its entirety. This warranty does not include reimbursement for incon-
venience, installation, setup time, loss of use, unauthorized service, or return shipping charges.
This warranty covers only DESA Specialty Products
components that a customer uses in conjunction with our products.
THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY
WARRANTY, REPRESENTATION OR CONDITION OF MERCHANT ABILITY OR THAT THE PRODUCTS ARE FIT FOR
ANY PARTICULAR PURPOSE OR USE, AND SPECIFICALLY IN LIEU OF ALL SPECIAL, INDIRECT, INCIDENTAL,
OR CONSEQUENTIAL DAMAGES.
REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE CUSTOMER AND THERE SHALL BE NO LIABILITY
ON THE PART OF DESA SPECIALTY Products
DAMAGES, INCLUDING BUT NOT LIMITED TO ANY LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT FORE-
SEEABLE. Some states or provinces do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you. Proof of purchase is required for warranty claims.
All manuals and user guides at all-guides.com

TROUBLESHOOTING GUIDE

TECHNICAL SERVICE

™
TEN YEAR LIMITED WARRANTY
™
FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL
™
SYMPTOM POSSIBLE CAUSE
Lights stay on 1. A flood lamp is positioned too close to
continuously.
2. Light Control is pointed toward a heat
3. Light Control is in Manual Mode.
Lights flash on 1. Heat or light from the lamps may be
and off.
2. Heat being reflected from other objects
3. Light Control is in the Test mode and
4. Light may be leaking through the
assembled products and is not extended to other equipment and
4
the sensor or pointed at nearby objects
that cause heat to trigger the sensor.
(Reposition the lamp away from the
sensor or nearby objects).
source like an air vent, dryer vent, or
brightly-painted heat-reflective sur-
face. (Reposition sensor).
(Switch to Auto.)
turning the Light Control on and off.
(Reposition the lamps away from the
sensor).
may be affecting the sensor. (Reposi-
tion sensor).
warming up.(Flashing is normal under
these conditions).
floodlamp reflectors. (Make sure the
metal lamp protectors are installed.)
598-1158-01