Sears Kenmore 665.7596 Serie Para El Instalador página 20

Estufa de gas a doble combustible con autolimpieza
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Oven
The oven light is a standard 40-watt appliance bulb. It will some
on when the oven door is open. It will not work during the Serf-
Cleaning cycle. When the oven door is closed, press the OVEN
pad to turn on and off.
Before replacing, make sure the oven and cooktop are cool and
the control knobs are off.
To Replace:
1.
Unplug range or disconnect
power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise
to remove.
3. Turn bulb counterclockwise
to remove from socket.
4.
Replace bulb, then bulb cover by turning clockwise.
5.
Plug in range or reconnect power.
For normal range use, it is not suggested to remove the oven
door. However, if necessary, follow these instructions. The oven
door is heavy.
Before Removing:
1.
Use a putty knife or screwdriver and insert it at the bottom
corner of the door stop clip.
1. Door Stop Clip
2.
Pry door stop clip free and remove from front frame hinge
slot. Take care not to scratch finish.
3.
Repeat procedure for other door stop clip.
To Remove:
1. Open the oven door. Insert door removal pins, included with
your range, into both hinge hangers. Do not remove the pins
while the door is removed from the range.
\
\
1
1. Removal Pins
2. Hinge Hanger
2. Carefully close the door until it rests against the door removal
pins.
3. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
4.
Pull door straight up, then toward you. Hinge hangers will
slide out of front frame hinge slot. Do not remove door
removal pins until the door is replaced on the range.
To Replace:
1. Grasp the door on the sides with your fingers on the front of
the door and your thumbs on its inside surface.
2.
Hold oven door so that the top edge of each hinge hanger is
horizontal. Insert hinge hangers into the front frame hinge
slots.
3. Tilt top of door toward range. Slide hinge hangers down onto
front frame support pins. Make sure the hinge hangers are
fully seated and engaged on the support pins.
1. Hinge Hanger
2. Door Frame Hinge
3. Support Pins
4.
Insert the door stop clip with its angular surface at the top of
the frame hinge slot, then push in the bottom of the clip until
its flanges are flush with the front frame.
5. Open the door completely and remove the door removal pins.
Save door removal pins for future use.
6. Close the door.
2O

Publicidad

Tabla de contenido
loading

Tabla de contenido