Range Care; Self-Cleaning Cycle - Sears Kenmore 665.7596 Serie Para El Instalador

Estufa de gas a doble combustible con autolimpieza
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

RANGE CARE
_ _
_
,,%
_
_ _ _
Burn Hazard
Do not touch the oven during the
Self-Cleaning cycle.
Keep children away from oven during
Self-Cleaning cycle.
Failure to follow these instructions can result
in burns.
IMPORTANT:
The health of some birds is extremely sensitive to
the fumes given off during the Self-Cleaning
cycle. Exposure to
the fumes may result in death to certain birds. Always move birds
to another closed and well ventilated room.
Self-clean the oven before it becomes heavily soiled. Heavy soil
results in longer cleaning and more smoke.
Keep the kitchen well-ventilated
during the Self-Cleaning cycle to
help get rid of heat, odors, and smoke.
Do not block the oven vent(s) during the Self-Cleaning
cycle. Air
must be able to move freely. Depending on your model, see
"Oven Vent" or "Oven Vents" section.
Do not clean, rub, damage or move the oven door gasket. The
door gasket is essential for a good seal.
Prepare Oven:
Remove the broiler pan, grid, cookware and bakeware and,
on some models, the temperature
probe from the oven.
Remove any foil from the oven because it may burn or melt,
damaging the oven.
Remove oven racks to keep them shiny and easy to slide.
See "General Cleaning" section for more information.
Hand clean inside door edge and the 11/2in. (3.8 cm) area
around the inside oven cavity frame, being careful not to
move or bend the gasket. This area does not get hot enough
during self-cleaning to remove soil. Do not let water, cleaner,
etc. enter slots on door frame. Use a damp cloth to clean this
area.
Wipe out any loose soil to reduce smoke and avoid damage.
At high temperatures,
foods react with porcelain. Staining,
etching, pitting or faint white spots can result. This will not
affect cooking performance.
Prepare Cooktop
and Storage Drawer:
Remove plastic items from the cooktop because they may
melt.
Remove all items from the storage drawer (or warming drawer
on some models).
IMPORTANT: The heating and cooling of porcelain on steel in the
oven may result in discoloring,
loss of gloss, hairline cracks and
popping sounds.
LOGICLEAN
TM
Self-Cleaning
Cycle
How the Cycle Works
The LOGICLEAN Self-Cleaning cycle is a "one-touch"
step that
uses very high temperatures
and dissolves soil to a powdery ash.
"Logl" setting will automatically
determine the length of cleaning
time needed based on the number of times the oven has been
used since the last self-clean cycle. Maximum clean time is 4
hours 30 minutes, and minimum is 2 hours.
The oven will automatically
shut off once it is clean. The door will
not unlock until the oven cools.
Once the oven has completely
cooled, remove ash with a damp
cloth. Do not wipe down any of the inside surfaces until the oven
has completely cooled down. Applying a cool, damp cloth to the
inner door glass before it has cooled completely
could result in
the glass breaking.
The soil level can be manually set to light, average or heavy soil
levels by repeatedly pressing LOGICLEAN.
To Self-Clean:
Before self-cleaning,
make sure the door is closed completely or
it will not lock and the cycle will not begin.
1.
Press LOGICLEAN.
2.
Press START.
The oven door will lock in 6 seconds and "cln Logl," "HEAT,"
"ON," "LOCKED," and "CLEAN" will appear on the display.
The door will not unlock until the oven cools. The cycle time
includes a 30 minute cool down time.
When the cycle is complete and the oven cools, "End" will
appear on the display and "LOCKED" will disappear.
3.
Press STOP/CLEAR or open the door to remove "End" from
the display.
4. Close doo_
The time of day will appear on the display.
To Delay Start Self-Clean:
Before delay starting Self-Clean, make sure the clock is set to the
correct time of day. See "Clock" section. Also, make sure the
door is closed completely
or it will not lock and the cycle will not
begin.
1.
Press LOGICLEAN.
2.
Press DELAY START.
Press the HOUR/MIN "up" or "down" arrow pad to set time of
day to start the Self-Cleaning
cycle.
3.
Press START.
The door will automatically
lock, and "LOCKED," "DELAY"
and the time of day will appear on the display.
When the start time is reached, the oven will automatically
turn on.
When the cycle is complete and the oven cools, "End" will
appear on the display and "LOCKED" will disappear.
4.
Press STOP/CLEAR or open the door to remove "End" from
the display.
5. Close doo£
The time of day will appear on the display.
18

Publicidad

Tabla de contenido
loading

Tabla de contenido