Cooktop Use - Sears Kenmore 665.7596 Serie Para El Instalador

Fire Hazard
Do not let the burner flame extend beyond the
edge of the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in
death or fire.
Electric igniters automatically light the surface burners when
control knobs are turned to LITE. Before setting a control knob,
place filled cookware onto the grate. Do not operate a burner
using empty cookware or while the grate is vacant.
To Set:
1. Push in and turn knob counterclockwise to LITE. All four
surface burners will click. Only the burner with the control
knob turned to LITE will produce a flame.
2. Turn knob anywhere between HI and LO. Use the following
chart as a guide when setting heat levels.
SETTING RECOMMENDED USE
LITE • Light the burner,
HI • Start food cooking.
• Bring liquid to a boil.
Mid-range • Hold a rapid boil.
(between HI and LO) • Quickly brown or sear food.
• To fry chicken.
• Maintain a slow boil.
• Fry or saute foods.
• Cook soups, sauces and gravies.
LO • Keep food warm.
• To simmer.
Power Burner • Provide highest heat setting
(left front burner)
SURESIMMER
TM
• Provide lowest simmer/heat setting.
(right rear burner) • Melt chocolate or butter,
COOKTOP USE
Power Burner
The left front burner is designed to give ultra-high power when it
is turned to HI. It can be used to rapidly bring liquid to a boil and
to cook large quantities of food. On some models both front
burners are Power Burners.
Cooktop Hot Indicator Light
The cooktop hot indicator light is located on the control console.
This indicator light will glow red as long as any surface cooking
area is too hot to touch, even after the surface cooking area(s) is
turned off.
'¢ _C ; "f
Ceek; op
The Cooktop Lockout prevents unintended use of the surface
burners. When the cooktop is locked out, the surface burners
cannot be turned on by the control knobs.
When power is first supplied to the range, or if the range loses
power, the surface burners will be in the Cooktop Lockout
position. The surface burners cannot be activated until power is
restored to the range and (or) the Cooktop Lockout is
disengaged.
To Lock/Unlock Coektep:
Before using, turn all control knobs to OFF. Press and hold the
TOP keypad for 5 seconds until a single tone and "Loc on" will
appear on the display. After 5 seconds, "Loc On" will disappear
from the display, and a picture of the cooktop will appear.
Repeat to unlock cooktop. "Loc OFF" will appear on the display
for 5 seconds and the picture of the cooktop will disappear from
the display.
2
3
1. Burner cap
2. Burner base
3. Alignment pins
4. Igniter
5. Gas tube opening
4
I .......... 5
I
REMEMBER: When range is in use or (on some
models) during the Self-Cleaning cycle, the entire
cooktop area may become hot.
IMPORTANT: Do not obstruct the flow of combustion and
ventilation air around the burner grate edges.
I Burner cap: Always keep the burner cap in place when using a
surface burner. A clean burner cap will help prevent poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
"General Cleaning" section.