Hella DynaView Evo 2 Instrucciones De Montaje página 11

Fig. 1
Cornering light in combination
with the reversing lamps for
better illumination alongside
the vehicle when manoeuvring.
Connect the white cable from the
3-pin connector with the plus
cable from the reversing lamp in
a favourable spot using incision
connectors.
Headlamp setting:
Adjusting
the speed signal:
1. Lights off, engine and
ignition off
2. Ignition on
A maximum of 10 seconds
may be allowed to pass
Replacing bulbs:
See fig. on page 6
11
Fig. 2
Using cornering light as fog
light.
Connect the extension cable to
the separate switch using cable
lugs (white/brown/blue).
(Part no. 6EH 007 946 041)
Connect brown to ground, blue
and white according to circuit
diagram.
The lamps are set in the same
way as fog lamps. In order to
achieve optimum illumination of
between steps 2and 5
(inclusive) otherwise
the system will not be
calibrated!
A maximum of 5 minutes
may be allowed to pass
between steps 2 and 11
(inclusive) as otherwise
the electronic system will
return to normal operation!
Another tip:
Always keep headlamp lenses
clean. Dirt can absorb up to
80% of the light output.
If the vehicle already has fog
lights fitted, these must be
dismantled first. Insulate the old
ground cable. Connect the old
plus cable to the white cable of
the 6-pin connector using incision
connector. Switching is via the
fog light switch as before. Insulate
the connectors on the other side
in the same way.
the roadway, the headlamps have
to be set exactly by a qualified
garage. Following headlamp
3. Engine on
4. Switch the lights on/off => 3
times briefly in succession
5. Switch on the hazard flashers
and switch off again
immediately after flashing
once.
6. Switch the lights on
7. Drive off
8. Cornering light goes off
automatically
You drive safely when you can
see and be seen well.
Fig. 3
Connection to speed signal
6-pin connector
Violet cable.
Ask at your repair garage where
you can tap the signal in your
vehicle type. Further information
about the speed signal can be
found under www.hella.com
setting tighten the screws.
9. Activate the hazard
warning light at 40 km/h
(the direction indicators have
to flash at least once)
10.Following step 11 both
cornering lights will flash
for 5 seconds to confirm
calibration.
If you have any questions or
installation problems:
Call Hella Customer Services