Nolan N71 Seguridad E Instrucciones página 19

5.2.3 Insert the rear right, central and left flaps of the liner into the relevant support seats
in the helmet neck-ring area (Fig. 13). To perform this step, act as follows: slightly
deform the shell sealing edge and push the flaps until they are completely hooked
to the support.
Note: Check the correct assembly of the liner front area by lifting / lowering the VPS.
These movements should be smooth. If this is not the case, repeat the steps 5.1.7 and
5.2.2.
5.2.4 Hook the zip of the roll-neck and close it starting from the left side of the shell trim. Fit
the zip flap in the special anti-flutter elastic (Fig. 11).
5.2.5 Hook the left roll-neck eyelet to the frame fixed to the outer shell (Fig. 12), making
sure that the frame's central hole is free.
5.2.6 Insert the band and the left chin strap into the slot of the left cheek pad.
5.2.7 Put the left cheek pad against the polystyrene inner cheek pad and push the padding
near the snap fasteners on its back in order to fasten them to their seats (Fig. 10).
Warning: the buttons are not hooked until a click is heard.
5.2.8 Check that the strap comes out properly from the cheek pad.
5.2.9 Repeat steps 5.2.5 to 5.2.8 on the other side of the helmet.
WARNING!!!
- Remove the padding only when cleaning or washing is required.
- Never use the helmet if the inner comfort padding and the cheek pads have not
been correctly and completely restored.
- Always check the correct adjustment of the chin strap (see instructions in the
attachment), depending on whether the roll-neck is present or not.
- Delicately hand-wash in lukewarm water (max. 30°C) and neutral soap.
- Rinse off with cold water and dry up at room temperature away from direct sunrays.
- Never machine-wash the comfort padding.
- The inner polystyrene is an easily deformable material, in fact it is apt to change or
get partially destroyed to help absorb shocks.
- Use a damp cloth to clean it and let it dry at room temperature away from direct
sunrays.
- Do not modify the helmet's internal polystyrene components in any way.
- Never use tools or equipment of any sort to carry out the steps described above.
6) HELMET IN FULL-FACE CONFIGURATION (P)
6.1 CHIN GUARD RELEASE
6.1.1 Open the visor completely.
6.1.2 Take hold of the left cheek pad and pull towards the inside of the helmet to undo
the first snap fastener from the chin guard frame (Fig. 15 A).
6.1.3 Press the release lever A on the shell frame while sliding the chin guard towards the
front of the helmet (Fig. 15 B).
Carry out the same steps on the right side of the helmet.
6.1.4 Make sure that the roll-neck eyelet is correctly place on the frame fixed to the outer
shell and hook the left and right pad buttons.
19