Nolan X-lite X-402 T Seguridad E Instrucciones página 15

3 Visor adjustment (Fig. 3)
The visor mechanism is equipped with a visor clearance take-up system that ensures
that the visor is pulled down and effectively against the window trim. This is why the
mechanism's support has an upper and lower reference tooth. The helmet is deliv-
ered with a correctly adjusted system. When using the helmet, regularly check that
the visor adheres perfectly and is in line with the lip trim of the window trim when it
is pulled down all the way. If this is not the case, proceed as follows:
3.1 Disassemble the visor (see section 1) and check in which position of the upper
reference A1 and lower reference A2 teeth the mechanism is located.
3.2 Loosen the two screws B1 and B2 on the visor mechanism using a 2.5 mm Allen
screw wrench.
3.3 Lift the mechanism from its support and move it forward or backward according
to the adjustment to be made. Then lower the mechanism into its support so that
upper A1 lower A2 adjustment teeth are in the same position.
3.4 Tighten both screws B1 and B2.
3.5 Repeat the same steps on the other side of the helmet.
3.6 Mount the visor (see section 2).
3.7 Check contact between the visor and the trim.
ATTENTION!!!
- After each assembly or disassembly procedure of the different parts, check that
the visor mechanism works properly by pulling the visor up and down; if neces-
sary, repeat the steps described above.
- Do not remove the visor pulling up/down mechanisms from the shell.
• CHIN GUARD
1 CHIN GUARD RELEASE
1.1 Open the visor completely.
1.2 Pull the right and left red chin guard release levers downwards and at the same
time remove the chin guard from the helmet, by pulling it towards the outside
(Fig. 4).
WARNING: Every time you wish to release the chin guard to use your helmet in
the JET version, insert the right and left CHIN GUARD COVERS into the slots on
the right and left side frames and push them completely to the inside of the hel-
met (Fig. 5).
Note: The two CHIN GUARD COVERS are different from each other and are
marked on their back as R (Right) and L (Left).
2 CHIN GUARD FASTENING
2.1 Open the visor completely.
Before fastening the chin guard to the helmet, remove the CHIN GUARD COV-
ERS by performing the following operations:
15