Nolan X-lite X-402 T Seguridad E Instrucciones página 19

- The VPS antifog/antiscratch treatment remarkably reduces fogging. Protracted
periods of adverse weather and/or environmental conditions might cause fog-
ging and/or formation of condensation on the VPS, which entails a reduction of
visibility and/or sharpness of vision: In this case, deactivate the VPS.
- In case of rain, the direct contact of raindrops with the antifog/antiscratch-treat-
ed VPS quickly reduces sharpness of vision, thus causing scarce visibility: In this
case, deactivate the VPS.
- The special VPS antifog treatment is usually sensitive to high temperatures or
heat sources. In this case, contaminations caused by contact with other materi-
als might occur. These contaminations will cause marks and stains to develop.
In these cases (e.g. when the helmet is kept in the top case), it is recommended
to make sure the visor is not touching other materials.
VPS DISASSEMBLY INSTRUCTIONS
1.1 To remove the VPS system from the helmet, open the helmet visor and lower
the VPS by pushing the side slider all the way forward, until the second click
(Fig. 12C).
1.2 Hold the left part of the VPS and pull it downward until the grip pawl is removed
from the VPS mechanism (Fig. 13)
1.3 Repeat the same steps on the right side of the VPS and remove it.
VPS ASSEMBLY INSTRUCTIONS
2.1 To assemble the VPS, open the helmet visor and make sure the side slider is in
forward position (Fig. 12C).
2.2 Insert the left end of the VPS into the left side guide until the grip pawl is hooked
in the mechanism (Fig. 13).
2.3 Repeat the same steps on the right side.
2.4 Make sure the VPS works correctly by moving the left side slider forward (Fig. 12B)
and backward (Fig. 12A) so that you can hear the clicks meaning that it enters
the relative positions.
If necessary, repeat the above-mentioned steps.
- If the visor and/or VPS opening/closing mechanisms are damaged or malfunc-
tioning, please contact a X-lite authorised dealer.
- Do not use the helmet if the VPS has not been assembled properly.
WARNING
- Since the VPS does not assure the same protection as that provided by the
visor.
• NFRS - NOLAN FOG RESISTANT SYSTEM
(Available as standard or optional accessory)
1 INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the exter-
nal levers for the pin adjustments are turned towards the inside (see photo 16).
19