Nolan X-lite X-402 T Seguridad E Instrucciones página 21

2 DISASSEMBLY
2.1 Remove the visor equipped with inner visor.
2.2 Widen the visor and unhook the inner visor from the pins Fig. 15.
2.3 Release the visor.
MAINTENANCE AND CLEANING
Remove the inner visor from the visor. Using a damp and soft cloth, gently clean it
with neutral liquid soap. Remove the soap under running water.
Dry the inner visor with dry and lukewarm air without wiping it.
To keep the features of the inner visor in good conditions over time, let the helmet dry
in a ventilated and dry place with the visor open after use.
Keep it away from heat sources and store it in a dark place.
Do not use solvents or chemical products.
USE CONFIGURATIONS (Fig. 17)
Using the helmet in its full configuration (chin guard fastened and visor closed) defi-
nitely guarantees a higher level of protection if compared with the other possible con-
figurations.
FRONT VENTILATION SYSTEM (Fig. 18)
The front air intake allows conveying air into the shell. Maximum efficiency is reached
when the VPS is active (lowered):
A) closed
B) open
TOP VENTILATION SYSTEM (Fig. 19)
The two top air intakes allow conveying air into the shell, independently from the VPS
position:
A) closed
B) open
REAR EXTRACTOR (Fig. 20)
The rear extractor ensures optimal heat dissipation.
CHIN GUARD VENTILATION SYSTEM (Fig. 21)
The chin guard ventilation system is controlled by two flaps:
A) closed
B) open
When in this position, the chin guard flaps allow conveying air directly to the visor, to
reduce visor fogging and formation of condensation.
21