Spool Pins; Presser Foot Lifter; Feed Dog Control; Converting To Free-Arm Sewing - Singer One Plus Manual De Instrucciones

SPOOL PINS

HORIZONTAL SPOOL PIN for normal
thread spool
Place thread spool on the pin and secure with a spool cap to
ensure smooth flow of thread. If the thread spool has a thread
retaining slit, it should be placed to the right.
Select the correct spool pin cap according to the type and
diameter of spool being used. The diameter of the spool pin
cap should always be larger than that of the spool itself.
VERTICAL SPOOL PIN for large thread
spool
Attach the spool pin. Place the felt disc over it. Place a thread
spool on the spool pin.

PRESSER FOOT LIFTER

There are three positions for your presser foot.
1. Lower the presser foot to sew.
2. Raise the lifter to the middle position to insert or remove
fabric, and to change presser foot.
3. Lift it to its highest position to insert or to remove thick
fabric.
NOTE: If you start the machine with presser foot raised,
it will alert you with a beep sound to lower the presser
foot to sew.

FEED DOG CONTROL

The feed dogs control the movement of the fabric that is
being sewn. They should be raised for all general sewing
purposes and lowered for darning, freehand embroidery and
monogramming so that you, not the feed dogs, are moving the
fabric.
Lower the feed dogs by removing the extension table and then
pushing the feed dog lever toward the machine.

CONVERTING TO FREE-ARM SEWING

Your machine can be used either as a flat-bed or as a free-
arm model.
With the extension table in position, it provides a large working
surface as a standard flat-bed model.
To remove the extension table, hold it firmly with left hand and
pull it off to the left while pushing the release button (A) with
right hand as shown. To replace, slide the extension table
back into place until it clicks.
With the extension table removed the machine converts into
a slim free-arm model for sewing children's clothes, cuffs,
trouser legs, and other hard-to-reach places.
12
Spool
Bobine
Carrete
Felt disc
Rondelle feutre
Disco del pasador carrete
Vertical spool pin
Porte-bobine vertical
Pasador de carrete vertical
Thread retaining slit
Fente de retenue de fil
Ranura de retención de hilo
Spool pin cap
Chapeau de bobine
Tapa del pasador carrete
Down
Basse
Abajo
Spool pin
Spool
Porte-bobine
Bobine
Pasador carrete
Carrete
Feed dog lever
Levier de contrôle des griffes
Control de dientes
A