Spool Pins; Presser Foot Lifter; Feed Dog Control - Singer S900 Manual De Instrucciones

SPOOL PINS

Place thread spool on the pin and secure with a spool cap to
retaining slit, it should be placed to the right.
diameter of spool being used. The diameter of the spool pin
cap should always be larger than that of the spool itself.
of thread on the spool pin.

PRESSER FOOT LIFTER

There are three positions for your presser foot.
1. Lower the presser foot to sew.
2. Raise the lifter to the middle position to insert or remove
fabric, and to change presser foot.
3. Lift it to its highest position to accommodate thicker fabrics.

FEED DOG CONTROL

The feed dogs control the movement of the fabric that is
being sewn. They should be raised for all general sewing
purposes and lowered for darning, freehand embroidery and
monogramming so that you, not the feed dogs, are moving the
fabric.
Lower the feed dogs by removing the extension table and then
pushing the feed dog lever toward the machine.
To re-engage the feed dogs, push the lever back to the right.
Then, turn the hand wheel toward you one full revolution. You
will see the feed dogs raise back up.
16
Bobine
Carrete
Rondelle feutre
Porte-bobine vertical
Pasador de carrete vertical
Thread retaining slot
Tapa del pasador carrete
Basse
Porte-bobine
Pasador carrete
Bobine
Carrete
Feed dog lever
Control de dientes