Set Electricity Rate 1 And - elv EM 240 Instrucciones De Utilización Y De Seguridad

an electrical device. The power factor can be between
0 and 1. Ideally, the power factor is 1.
k

Set electricity rate 1 and 2

Note: the price per kWh is set to 0 on delivery.
Note: you can set two different electricity rates (e.g. daytime
and night-time rate) for the power cost meter. In order to use
this function, you must set the starting times for electricity rate
1 and 2.
IMPORTANT! Electricity rate 1 is automatically the rate
that was programmed first.
Tip! You can obtain details of the current price per kWh
from your electricity provider.
Note: please make sure that the top third of the LC display
1 shows the standard display (see "Display current").
Proceed as follows:
1. Press the "DOWN" button 4 until the price per kWh
symbol 19 ("PRICE KWh") appears in the centre of the
LC display 1 .
2. Press the "UP" button 5 so that four digits appear in
the bottom third of the LC display 1 . The
also appears.
Operation
symbol 15
GB 59