Setup Menu - Panasonic SC-HTE180 Instrucciones De Funcionamiento

AGC Auto gain control prevents sudden loud
sound by reducing the sound level
automatically when the input is too
high.
ON
OFF
LOW VOL Enhance the dialog in low volume
MODE condition.
ON
OFF
Select "OFF" to cancel this effect if the
dialog does not sound natural in low
volume condition.
Note:
The default setting is underlined. Changed settings will be
kept until it is changed again, unless otherwise indicated.
Audio format
You can view the current audio format.
Press and hold [SOUND] for a minimum of 4 seconds.
DOLBY Dolby Digital is the audio source.
DIGITAL
DTS DTS is the audio source.
PCM MULTI Linear pulse-code modulation is the
audio source.
PCM 2 channel pulse-code modulation is
the audio source.
ANALOG Analog is the audio source.
SBC Sub-band Coding is the audio source.
(Bluetooth
10
10
® mode only)

Setup Menu

1
Press [SETUP] repeatedly to select the setup item.
2
Press [R, T] repeatedly to select the desired
setting and then press [OK].
DIMMER Dims the display panel after
5 seconds of inactivity.
ON
OFF
AUTO POWER The system automatically switches off
DOWN if there is no audio input and when you
do not use it for 20 minutes.
ON
OFF
VOL Sets the volume limit to 50 when you
LIMITATION switch on the system although the
volume is set to above 50 before it is
switched off.
ON
OFF
BLUETOOTH This function allows you to connect a
STANDBY paired Bluetooth
system is in standby mode.
ON
OFF
The system will switch on
automatically when you connect a
paired Bluetooth
LINK MODE Change the Bluetooth
link mode to suit the connection type.
Make sure to disconnect the current
connected device ("BLUETOOTH
READY" is shown).
MODE 1: Emphasis on connectivity.
MODE 2: Emphasis on sound quality.
VIERA LINK Switch on the VIERA Link function.
ON
OFF
Select "OFF" when your HDAVI
Control device does not work
correctly with this system. ARC will be
disabled. Connect an optical digital
audio cable.
Switch off all connected devices and
then switch them on again after
changing the setting.
Note:
The default setting is underlined. Changed settings will be
kept until it is changed again, unless otherwise indicated.
device when this
®
® device.
connection
®