Uline RUBBERMAID H-3542 Manual De Instrucciones página 2

4. Screw top screw in about halfway and stop. Guide
screw through top hole in dispenser and let
dispenser drop down so screw sits in the narrow part
of the top hole. (See Figure 4)
Figure 4
5. Finish screwing in top screw and then screw in
bottom screw completely. (See Figure 5)
Figure 5
1. With dispenser open, set dispenser setting to "Light"
or "Normal." Use "Light" for a 1-2 stall restroom and
"Normal" for a 3-4 stall restroom. (See Figure 7)
Figure 7
2. Remove pull strap completely from refill cartridge.
(See Figure 8)
NOTE: Keep refill upright after opening.
3. Depress cage into base by pushing down and
twisting, eliminating space previously filled by pull
strap. (See Figure 8)
4. Insert refill into dispenser and close cover. (See Figure 9)
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 2 OF 6
MOUNTING CONTINUED
2
LOADING
1-800-295-5510
uline.com
MOUNTING WITH SCREWS AND WALL ANCHORS
1. Unlock dispenser cover by inserting prongs of key
into two white square holes in bottom of dispenser.
(See Figure 2)
2. Hold the opened dispenser to the wall and mark
screw holes with a pen or pencil. Only mark top
portion of the top hole. (See Figure 3a)
3. Using a 6mm drill bit, drill holes into wall at marked
locations. (See Figure 3b)
4. Insert wall anchors into drilled holes. Use a hammer
if necessary. (See Figure 6)
Figure 6
5. Screw top screw in about halfway and stop. Guide
screw through top hole in dispenser and let
dispenser drop down so screw sits in the narrow part
of the top hole. (See Figure 4)
6. Finish screwing in top screw and then screw in
bottom screw completely. (See Figure 5)
Figure 8
Figure 9
1014 IH-3542