Hilti VC 20‑U Manual Original página 8

Ocultar thumbs Ver también para VC 20‑U:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

intended could result in a hazardous situa-
tion.
n) Do not pull the wheels of the vacuum
cleaner over the supply cord.
o) The water level limiting device must be
en
cleaned regularly in accordance with in-
structions and checked for signs of dam-
age.
5.5 Mechanical
a) Follow the instructions concerning care
and maintenance.
b) Keep the appliance well maintained.
Check for misalignment or binding of
moving parts, breakage of parts and
any other condition that may affect
operation of the appliance. If damaged,
have the appliance repaired before use.
Many accidents are caused by poorly
maintained appliances.
5.6 Electrical
a) The appliance's supply cord plug must
match the outlet. Never modify the plug
in any way. Do not use any adapter plugs
with earthed (grounded) appliances. Un-
modified plugs and matching outlets will
reduce risk of electric shock.
b) Insert
the
plug
earthed/grounded power outlet which
has been correctly and safely installed
and
is
in
compliance
regulations.
c) If you are in doubt about the effective-
ness of the power outlet's earth/ground
connection, have it checked by a quali-
fied specialist.
d) Avoid body contact with earthed or
grounded
surfaces
radiators,
ranges and refrigerators.
There is an increased risk of electric shock
if your body is earthed or grounded.
e) Do not expose appliances to rain or wet
conditions. Water entering an appliance
will increase the risk of electric shock.
f) Check the appliance's supply cord at
regular intervals and have it replaced at
8
a Hilti service center if damage is found.
Check extension cords at regular inter-
vals and replace them if found to be dam-
aged.
g) Check the condition of the appliance and
its accessories. Do not operate the ap-
pliance and its accessories if damage is
found, if the appliance is incomplete or
if its controls cannot be operated fault-
lessly.
h) Do not touch the supply cord or
extension cord if they are damaged
while working. Disconnect the supply
cord plug from the power outlet.
Damaged supply cords present a risk of
electric shock.
i) The electric supply cord may be replaced
only with a cord of the type specified in
the operating instructions.
j) Damaged or faulty switches must be re-
placed at a Hilti service center. Do not
use the appliance if it cannot be switched
on and/or off correctly.
k) Have the appliance repaired only by a
trained electrical specialist (Hilti service
center) using genuine Hilti spare parts.
Failure to observe this point may result
in risk of accident to the user.
l) Do not abuse the cord. Never use the
cord for carrying, pulling or unplugging
the appliance. Keep the cord away from
heat, oil, sharp edges or moving parts.
Damaged or entangled cords increase the
in
a
suitable
risk of electric shock.
m) When operating an appliance outdoors,
use an extension cord suitable for out-
with
local
door use. Use of a cord suitable for outdoor
use reduces the risk of electric shock.
n) In case of an interruption in the elec-
tric supply: Switch the appliance off and
unplug the supply cord.
o) Avoid using extension cords with multi-
ple power outlets and the simultaneous
such
as
pipes,
use of several appliances connected to
one extension cord.
p) Never spray the top section of the vac-
uum cleaner with water: this presents an
electrical hazard and may damage the
appliance.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Vc 40‑u

Tabla de contenido