Operating Instructions - TensCare Perfect mama+ Instrucciones De Uso

10.2. OPERATING
INSTRUCTIONS
ON/OFF
To turn the unit ON, press the
ON
ON button and hold for 3 to 5
seconds until
shows.
OFF
To turn the unit OFF, press the
OFF button and hold for 3 to 5 seconds
until the display stops.
The unit will turn OFF automatically if it
is left at zero strength for more than 5
minutes.
When switching the unit on, the display
shows that the unit is automatically set
in programme A at zero strength.
Note: Always check unit is
OFF before
removing electrode pads.
The backlight will turn off 10 seconds
after the last button press.
On the front of the unit there are six
buttons:
STRENGTH CONTROLS
The buttons marked ▲ and ▼ are the
strength controls.
To increase strength in steps
▲
of 1, press and release the ▲
button.
▼
The strength level is shown on
the LCD.
The strength control buttons will not
operate until the unit is properly
connected to you. Perfect mama+
detects a disconnection
automatically returns the strength to
zero.
The unit has 50 levels of strength in
programme A & B, and 60 levels in
programme C. If you hold down the
button for 3 to 5 seconds, the strength
will start scrolling.
the display
You may feel nothing over the first few
presses. Continue pressing until the
sensation is strong but comfortable.
Further increases during use may be
necessary if your body becomes used
to the sensation.
To decrease the strength, press and
release the lower part of the button
marked ▼.
The yellow LED on the output socket
indicates that there is an active output.
The display will remain on for 5 seconds
after the plug is removed.
applying or
PROGRAMME CONTROL
Perfect mama+ has 3 different preset
programmes lettered A, B and C.
Each time you press and release the P
button, the programme changes and
the letter is shown on the LCD.
Each time the programme changes the
intensity of stimulation is automatically
reduced by 50%.
TIME IN LABOUR
your Perfect mama+.
The letter T and the time will appear on
the screen. The time in labour is
displayed in hours and minutes. After 3
seconds, the display reverts to normal.
and
16
The button marked P is the
P
programme
Press this button to see how
T
long you have been using
control. The