Beninca CP.K Manual De Instrucciones página 8

TCA Adjustment of the automatic close time if enabled by Dip-Switch 1.
Adjustment ranges from 1 sec to max 90 sec
AMP-O Adjustment of the amperometric sensor obstacle detection sensitivity during the open
cycle.
AMP-C
Adjustment of the amperometric sensor obstacle detection sensitivity during the close
cycle.
Turn the trimmers clockwise (+) to increase the torque, turn them anticlockwise (-) to reduce
the torque.
Adjustment of trimmers AMP-O and AMP-C must comply with statutory regulations.
If an obstacle is detected:
When opening, the gate is stopped.
When closing, the gate stops and opens for about 3 sec.
DIP 1 "TCA"
DIP 2 "COND."
DIP 3
DIP 4 "Radio"
CAUTION! This adjustment strongly affects the safety of the gate automation.
Make sure that the gate thrust complies with statutory regulations.
If the gate speed is changed the amperometric sensor must be calibrated accordingly.
The secondary circuit of the transformer has 2 Faston terminals to select the motor speed and slowdown
speed.
Selecting the motor speed
The Faston for the motor speed adjustment is identified by a white wire connected to terminal 21.
The maximum motor speed is obtained by hooking up the Faston to the 30V output, the minimum motor
speed is obtained by hooking up the Faston to the 20V output.
Selecting the motor slowdown speed
The Faston for the motor slowdown speed adjustment is identified by a red wire connected to terminal 19.
The maximum slowdown speed is obtained by hooking up the Faston to the 20V output, the minimum
slowdown speed is obtained by hooking up the Faston to the 15V output.
The control unit is fitted with a built-in radio module for receiving remote controls both with fixed codes
and variable codes (see dip-switch 4 functions), with a frequency of 433.92MHz.
For a transmitter to be used, the module first has to self-learn its code. The memorise procedure is
illustrated below, the module can memorise up to 64 different codes.
Memorising a new transmitter by activating the P.P. function
- Press the PGM button once for 1sec and the Power LED will start blinking at 1 sec intervals.
- Press the transmitter button within 10 sec to memorise with the P.P. (Step-by-step) function.
8
Trimmer functions
Dip-Switch functions
Enables or disables automatic closing.
Off: automatic closing disabled
On: automatic closing enabled
Enables or disables the high traffic function.
Off: High traffic function disabled.
On: High traffic function enabled. The P.P. (Step-by-step) or transmitter signal is
ignored during the open cycle and the TCA cycle (if enabled).
Not used.
Enables or disables transmitters with programmable codes
On: Radio receiver enabled exclusively for rolling-code transmitters.
Off: Receiver enabled for both rolling-code and programmable transmitters
(self-learn and dip-switch) .
Motor speed adjustment
Configuration with built-in receiver