Switching On/Off - MBM GBR77 Instrucciones Para El Funcionamiento

5. 3.
INSTRUCTIONS FOR USE

Switching On/Off

When lighting for the first time, wait for the
possible formation of air inside the gas circuit to
fully escape from the duct.
When the operations described on the previous page have
been performed successfully, do as follows to begin cooking:
Press the button (Fig. 7A) for about 20" and simultaneously
press the piezoelectric button several times (Fig. 8) until the
pilot light is lit.
After approximately 20" look to see if the pilot light remains lit
(Fig. 9). If so, release the button.
The pilot light can be seen through the hole on the panel.
Repeat the operation if after 20" the pilot light is
not yet lit. If the pilot light does not ignite, contact
the technical assistance Centre.
When the pilot light has been lit, turn the thermostat knob to
the switch-on position (Fig. 7B) and adjust the temperature
(Fig. 7C) using the 8 thermostat positions. See layout below.
POSITION
KNOB
1
2
3
4
5
6
7
8
Turn the thermostat knob to "Zero" (Fig. 7D) to switch the
burner off.
When the work cycle is over, in order to speed up
a new production cycle, you may turn the burner
off while leaving the pilot light on.
Press the "0" button (Fig. 7E) to block the gas supply to the
pilot light and stop the appliance completely.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
TEMPERATURE
90°C
130°C
180°C
210°C
240°C
260°C
290°C
300°C
- 12 - - 12 - 12 12
- 700
A
E
7
Fig.
B
C
D
Fig.
A
9
8
Fig.