Securing The Silencer - Dometic ePower T Instrucciones De Montaje

All manuals and user guides at all-guides.com
ePower T, ePower T LPG
7.3

Securing the silencer

Observe the following instructions when installing the exhaust pipe:
 Do not create any sharp bends which will inhibit the flow of exhaust
fumes.
 Align the manifold (fig. 7 1, page 7) along the housing to ensure greater
damping of vibration.
 Use the exhaust pipe extension to divert the exhaust fumes (fig. 7 2,
page 7) (see chapter "Accessories" on page 26).
Secure the extension to the vehicle floor (fig. 7 3, page 7).
➤ Secure the silencer (fig. 7 4, page 7) as in one of the alternatives shown:
fig. 8, page 7 to fig. b, page 8.
7.4 ePower T only: Installing the tank and fuel supply
line
Please observe the following instructions for the installation location:
 The tank bottom must be positioned at a maximum of 0.3 m below the
bottom of the generator.
 The top of the tank must not be higher than the top of the generator
otherwise the fuel will not be able to feed in.
➤ Lay the fuel line as straight as possible.
➤ Secure the tank, see fig. c, page 9 and chapter "ePower T only: Con-
necting the float" on page 36.
7.5 ePower T LPG only: Connecting the gas supply
The ePower T LPG generator is connected to the low pressure regulator
(30 millibar, minimum flow quantity 1.2 kg/hour) on the LPG cylinder.
➤ Lay the gas line. Use only metal pipes suitable for gas lines.
➤ Connect the gas line (fig. d, page 9).
For connections with copper pipe, use the flexible tube and nut
connectors (fig. 1 7, page 2)
EN
Installation
31