Securing The Silencer - Dometic TEC 30D EV Instrucciones De Montaje

TEC30D EV
Hanging installation (A)
Proceed as follows:
➤ Remove the brackets (fig. 3 1, page 4).
➤ Mount the brackets upside down (fig. 3 2, page 4).
You can determine the exact position of the drillings using the drilling template
which is included in the packaging (fig. 3 B, page 4).
➤ Fasten the mounting brackets (fig. 4 1, page 4; accessory, not included in the
delivery) to the desired place.
➤ Fix the generator together with the dampers (fig. 4 2, page 4).
Upright installation (B)
Proceed as follows:
➤ Drill the mounting holes at the desired area using the drilling template which is
included in the packaging (fig. 5, page 5).
➤ Drill the drain hole using the drilling template which is included in the packaging
(fig. 5, page 5).
➤ Fit a seal (fig. 6 1, page 5) made of fire-retardant rubber with a thickness of at
least 5 mm into the drain hole.
➤ Place the generator in the desired area.
➤ Fix the generator together with the dampers (fig. 7 1, page 5).
9.3

Securing the silencer

Observe the following instructions when installing the exhaust pipe:
• Do not create any sharp bends which will inhibit the flow of exhaust fumes.
• Comply with the minimum bending diameter of 160 mm to avoid cracks in the
exhaust pipe.
• Use the exhaust pipe extension to extent the the exhaust pipe (see chapter
"Accessories" on page 21).
Secure the extension to the vehicle floor.
➤ Secure the silencer (fig. 8 7, page 6) as in one of the alternatives shown in
fig. 9, page 6 to fig. c, page 8.
DE
Installation
23