Ideal 61-955 Manual De Instrucciones página 7

RC-955 Display
1. Bright, 2-digit red LED display. (180° Rotating)
2. Displays the powered line status received
from the transmitter.
3. "0-99" numeric indication of signal strength.
4. Indicator lights when audible tone is disabled.
5. Peak detector shows instantaneous changes
in signal strength.
RC-959 Display
1. Super-bright OLED display (90° rotating).
2. Displays the powered line status received
from the transmitter.
3. Indicates On/Off status of the audible tone.
4. Low Battery Indicator. Flashes when 10%
battery life remains.
5. "0-99" numeric indication of signal
strength.
6. Displays the sensitivity setting.
7. Peak detector shows instantaneous
changes in signal strength.
Additional Notes
• Sensitivity mode selection – general guidelines:
• Start out at maximum sensitivity (
If the receiver is too sensitive, then reduce the sensitivity using the
the receiver's display does not peg at "99" continuously.
• Use
(rather than the 25' lead and a remote return path setup), (b) in open circuits, (c)
underground, (d) and anywhere else more signal detection is needed.
• Use
signal saturation (display is pegging at "99" continuously).
• Use
return path, (b) and when previous mode has signal saturation of "99."
• Use mode for (a) identifying circuit breakers and fuses, (b) pinpointing individual
wires from a bundle, (c) and when previous mode has signal saturation.
• Receiver Orientation
• The indication of received signal intensity depends on how the receiver is pointed
in relation to the source of the signal. If the receiver is pointed away from the signal
source then there will be a low value indicated on the receiver. If the receiver is
rotated about the axis of main antenna sensitivity, the signal varies in strength as the
antenna is pointed at and then away from the circuit being traced.
mode for tracing: (a) in closed circuits while using the outlet plug adapter
mode to reduce the level of sensitivity if the highest sensitivity range has
mode for tracing (a) in closed circuits while using the 25' lead and a remote
2
3
4
2
3
) until the receiver finds the circuit under test.
Page 7
1 4 5
1
5 6
button until
7