BEFORE USING FOR
THE FIRST TIME
Before using your Cuisinart
Gooseneck Kettle for the first time, we
recommend rinsing the kettle with water
to remove any dust or residue remaining
from the manufacturing process.
OPERATION/HEATING
1. Lift kettle of the base and remove the lid.
2. Add fresh, cold water to fill the kettle. Do
not fill past 1.0L mark – overfilling could
cause water to boil over.
3. Place the lid back on the kettle by lining
up the arrows and press down until it
locks shut.
NOTE: be sure that the arrow on the lid
is lined up with the arrow on the handle
before heating water.
4. Place the kettle back onto the power
base and plug in the unit.
NOTE: The red ON/OFF indicator light
will appear.
5. Touch and hold the ON/OFF button for 1
second to power the unit on. The Keep
Warm and Temperature Selection
buttons will illuminate and the LCD will
display the preset temperature.
NOTE: During the heating process, it will
display the current water temperature
and the setting temperature alternately.
6. Use the Temperature Selector + or -
button to scroll through until desired
temperature is displayed on the LCD.
NOTE: Each time the Temperature
Selector + or - is pressed, the
temperature will increase in 5-degree
increments.
NOTE: Keep Warm will be selected by
default unless you deselect it by tapping
the indicator once.
7. The heating process will begin after 5
seconds. The ON/OFF indicator will blink
and the LCD will display the real-time
temperature and preset temperature
alternately.
NOTE: To turn kettle off at any time,
simply press the ON/OFF button again.
The last selected settings will remain in
®
Digital
6 6
the kettle's memory until the unit is
unplugged.
8. Once your kettle has reached the
selected temperature, the unit will beep.
The Keep Warm, + and - button lights
will stay on, the ON/OFF lights will blink,
and LCD display preset temperature
(same as current temperature) will be
maintained for 30 minutes.
9. Lift the kettle off the base to pour water.
All lights will turn off while the kettle is
off the base, and LCD will display "---"
and blink.
10. Return kettle to the base. Indicator
lights will go back on and the Keep
Warm cycle will pick up right where
it left off.
MEMORY FEATURE
The kettle features an internal "memory"
that lets you leave the kettle off the base
for up to 2 minutes without it going into
standby mode. When returned to the base,
it will restart the heating and/or Keep Warm
cycles right where they left off.
NOTE: If kettle goes into standby mode
before it's returned to base, simply
reselect your temperature and press
and hold ON/OFF to restart.
KEEP WARM MODE
Keep Warm is the kettle's default function
that automatically maintains selected
temperature for 30 minutes. If you have
selected the Boil, your unit will hold a tem-
perature just below boiling during the
Keep Warm cycle. To bring water back
to a rolling boil, press OFF then press &
hold ON/OFF to reboil.
Keep Warm can be turned off by pressing
the Keep Warm button at any time before
or during the heating cycle. The selected
temperature will remain on the LCD until
water temperature has dropped below the
selected temperature.