Erreka CICLÓN Manual Del Usuario página 13

INSTALLATION OF THE MOTOR
To install the CICLÓN motor, follow the following steps closely:
1. Fix bracket A to the pillar using rawplugs suited to the pillar material
PLEASE NOTE: the bracket should be perfectly horizontal. Use a spirit level to accurately position the bracket
2. Fix the motor reducer onto bracket A using the 4 screws F and the relevant nuts and washers
3. Position the straight arm B on the motor shaft
4. Position the casing C on the straight arm and tighten the screw E after having inserted the washer D
5. Release the motor reducer
6. Close the gate, extend the arm to a maximum of 670 mm and mark the positions of the attachment H bracket orifices
7. Fix the bracket H onto the gate by welding or using appropriate screws for the gate-leaf material
11