PEERLESS Paramo PSP2 Instalación Y Montaje página 4

2-1
Single Keyhole Mounting
Insert 8-32 x 5/8" phillips screw (F) through the single hole mounting plate (B) and thread the 8-32 round key hole nut (J) a
few turns onto the 8-32 x 5/8" phillips screw as shown in figure 2.1 and figure 2.2. Be certain beveled edges of round key
hole nut face mounting plate. Do not fully secure 8-32 round key hole nut at this time. Insert 8-32 round key hole nut into
the key hole slot of speaker and slide upward into narrow end of key hole as shown in figure 2.3. Secure mounting plate to
speaker by gently pulling back on mounting plate and tighten 8-32 x 5/8" phillips screw.
J
fig. 2.1
B
2-2
Two-hole or Four-hole Mounting
Attach double hole mounting plate (A) to speaker
using two 1/4-20 x 1/2" screws (K) as shown in
figure 2.4. Four-hole speaker mount patterns can
be accommodated by positioning the mounting
plate diagonally as shown in figure 2.5.
2-3
Self-Tapped Mounting
Position double hole mounting plate (A) on back of speaker
in mounting location and use it as a template to mark
center of holes. Drill two pilot 1/8" (3 mm) dia. holes .5" (12
mm) deep. Do not drill deeper than .5".
CAUTION
• Do not drill or screw into the speaker where you could
possibly damage the internal components. If unsure of
location of internal components, check specifications
with manufacturer of the speaker.
Secure mounting plate to speaker with two #12 x 3/4" self
tapping screws (M).
Visit the Peerless Web Site at www.peerlessmounts.com
All manuals and user guides at all-guides.com
If 8-32 x 5/8" screw does
not fully secure mounting
plate to speaker,
spacer (I) can be used.
BEVELED
EDGES
F
J
F
fig. 2.4
I
B
fig. 2.2
SPEAKER
A
K
4 of 18
For customer care call 1-800-729-0307 or 708-865-8870.
SPEAKER
J
B
fig. 2.3
A
SPEAKER
fig. 2.5
SPEAKER
A
M
ISSUED:10-23-07 SHEET #: 087-9016-1