Installation Overview - Hach NX7500 Manual Del Usuario

• Do not replace the cable. If the cable has damage, contact the manufacturer.
• Make sure that the cable is not routed near hot surfaces. Make sure not to put heavy objects on
the cable.
• Make sure that there are no unwanted materials in the optical path.
• Immediately set the instrument to OFF if the probe sends out smoke, noxious fumes or gets hot.
Contact the manufacturer.

Installation overview

Figure 3 shows an example of the probe installation with a chain holder option.
example of the probe installation with a flow cell option. Refer to the installation documentation to
install the sensor.
Put the probe into the sample. Make sure that the optical path is fully immersed in the sample. Install
the sensor transversally to the flow direction of the sample so the particle on the windows are at a
minimum and the nano-layer function gives the optimum support. Refer to
Note: Make sure that the probe does not touch the ground.
Figure 3 Chain holder installation
Figure 4 shows an
Figure 5.
English 9