Care & Maintenance - Emmaljunga NXT90 CLASSIC Manual De Instrucciones Y Servicio

Care & Maintenance
General Care and Maintenance Instructions
• Never expose your pram to excessive sunlight for long
periods of time.
• Always use a raincover when it is snowing or raining.
• Never store your pram in cold and/or damp places.
• Should the chassis become wet, dry it off promptly.
Make sure vehicle is completely dry before storing.
• If the pram is used near the ocean or salted roads,
spray the chassis with a hose, and dry.
• Be careful during transportation and storage as the
surface of the chassis is fragile. Scratches that arise
after the sale are not a justifiable complaint.
Routine Inspection
• Regularly clean the chassis and metal parts of the ve-
hicle, dry off and lubricate thereafter all joints. WARN-
ING! Do not lubricate the telescopic bar. Spokes and
rims on all wheels should frequently be washed in hot
water and wiped off with a dry cloth. When the pram
is used during the winter time, cleaning of the pram
should be done at least once a week. Lack of mainte-
nance could cause rust.
• Clean the shafts (clean axles with a cloth).
Air Wheels (some models)
• If you need to inflate the tyre, use an air pump with an
adapter for a car.
• For air pressure see marking on the tyre. Please
neglect possible travel direction marks on the tires.
• The tyres are assembled in the factory. Any balancing
problems can be easily adjusted by releasing the air
and setting the tyres correctly on the rim and inflating to
the correct pressure.
• With ozone and UV radiation the tyres may have small
cracks. It does not affect handling and safety, and is not
a complaint basis.
WARNING
• Tyres can when in contact with PVC-flooring or other
plastic materials cause discoloration. Always use wheel
protection if the pram/stroller is stored on delicate
surfaces.
Check that:
• all chassis locking devices, seat unit and carrycot are
functioning properly.
• all rivets, nuts and bolts are firmly tightened and not
broken.
• all plastic parts are not cracked or broken.
• the wheel bearings are in a good condition.
• all zips and velcro straps are securely fastened.
• all elastic straps are in a good condition.
• the brake works.
• the tyre air pressure is correct (see marking on tyre).
• check regularly for damage to the chassis, carrycot and
seat unit.
PLEASE NOTE
• When in need of servicing with original parts and other
technical issues that require a professional evaluation,
Always get in touch with the store where you purchased
your product.
• The product you have chosen follows the guarantee
regulations.
NXT90 Classic v 1.0
The parking brake consists of moving parts and requires
regular maintenance to function correctly.
• To ensure effective functioning always make sure
that the parking brake is well lubricated.
Immediately remove sand, snow, ice and dirt from
any moving part of the braking system.
• Use a silicon or oil based lubricant to lubricate the brake
pedal, wheel axle and brake pins on both sides of the
pram brake at least once a month. Also lubricate the
release mechanism on the wheels on a similarly regular
basis.
• If you use your Emmaljunga pram/stroller eg. on
sandy beaches or under other dirty and wet
conditions make sure to take extra care of the
parking brake and maintain the braking system
and wheels as detailed above whenever needed.
Washing Instructions
• Hood:
Take off and extend the hood. Shower the hood from
the inside (interior fabric) with lukewarm water.Use mild
liquid soap as detergent. Cleanse it thoroughly. Drip
dry the fully extended hood.
• Seat fabric and 5-point harness:
Remove the seat fabric from the chassis and remove
the wooden seat board from the seat unit fabrics.
Hand wash seat fabrics in lukewarm water. Use mild
liquid soap as detergent. Cleanse thoroughly. Drip dry
the seat fabric. Only wipe the nylon straps and plastic
parts clean with a damp cloth. Do not hand wash.
Make sure the harness is dry before reassembly.
• Mattress
We recommend hand washing, drip dry.
• Carrycot:
Remove hood and mattress. Wipe the exterior fab-
ric and the interior nonwoven material, clean with a
damp cloth. Do not hand wash. Dry the pram body
in its fully extended position. Make sure the wooden
base is protected from any water.
General Information
• Ironing: If any fabric part needs to be ironed, always
use a 100 % cotton cloth in-between the iron and the
fabric to protect the fabric surface. Iron the exterior fab-
rics (100 %) polyester and the interior fabrics on gentle
heat (110°C on the iron).
• Make sure all parts are completely dry before reassem-
bly. Check all seams, edges and zips.
• You may apply a material protector on the exterior
fabric after washing. Always apply before reassembly.
WARNING
• Do not place your child/children in the stroller for at
least 24 hours after applying a material protector.
Reassemble after washing
W
ARNING
• Make sure all parts are assembled correctly according to
the instructions in this manual.
EN
37