2 Technical description
Attachment of accessories /
special options allows different
configurations for each series. The
specifications and notes on the
series apply also to customised
configurations of a series.
2 .1
INTENDED USE
This machine is a battery-powered setting tool for
inserting matching connectors into components.
Only blind rivet nuts and bolts are to be used as
fasteners with the setting tools described in this
manual.
2 .2
APPLICATION LIMITS
Safe and trouble-free operation of the machine is
not assured in the following cases:
•
The machine is not operated in accordance
with the operating manual.
•
The operator has not been instructed in the
use of the machine.
•
The machine is used outside the scope of the
intended use.
2 .3
SCOPE OF SUPPLY
The battery is only partially charged
on delivery and must be fully
charged before the first use, see
chapter 3.2.
•
Setting tool
•
1 or 2 batteries 20 V/2 Ah (depending on the
version ordered)
•
Universal quick charger 220 V
•
Cable with mains plug for the universal quick
charger
•
5 threaded mandrels: M4, M5, M6, M8, M10
•
5 nosepieces for blind rivet nuts/bolts:
M4, M5, M6, M8, M10
•
Belt clip
•
Rivet application plate
•
Hanger bracket
•
SD card with USB adapter
•
Quick guide
Threaded sleeves are required
for the setting of blind rivet bolts;
these are not included in the scope
of supply and must be ordered
separately.
34 | English
2 .4
SETUP AND DIMENSIONS
The setup and appearance of the
machine may differ from this figure,
depending on the configuration.
Setup
See figure a
No .
Designation
1
Nosepiece
2
Front sleeve
3
Union nut
4
SD card slot for updating of the software,
see chapter 5.2
5
Hole for hanger bracket
6
Screen, see chapter 2.5
7
Keys, see chapter 2.5
8
RGB LED to indicate the operating
status, see chapter 9.1
9
Label / type plate
10
Handle
11
Thread (on both sides) for belt clip or rivet
application plate
12
Battery release button
13
Battery charge status indicator
14
Battery
15
LED for illumination of the riveting point
16
Trigger