Load Stored Memory Cells; Operation - Honsel Rivdom eVNG 2 Instrucciones De Uso

3 .7

LOAD STORED MEMORY CELLS

Precondition:
• The desired threaded mandrel or threaded
sleeve and the desired nosepiece are fitted,
see chapter 3.4.
• There is a drill hole for the fastener in the part.
• The setting tool is unlocked, see chapter 3.3.
• The setting tool has been set up and a memory
cell has been assigned, see chapter 3.5.1.
1. Insert the battery into the setting tool.
2. Press the trigger briefly.
The unlocked starting mask / working
»
mask appears on the screen.
3. Hold the OK key pressed for 2 seconds.
The Enter PIN keypad appears on the
»
screen.
4. Enter the PIN using the arrow keys.
5. Confirm the selection with the OK key.
The Rivdom eVNG Main menu appears on
»
the screen.
6. Select sub-menu Service using the arrow keys.
The Service Menu appears on the screen.
»
7. Select sub-menu Storage using the arrow keys.
The Storage Menu appears on the screen.
»
8. Navigate to the number box behind Load setup
Enter No. using the arrow keys and confirm
with the OK key.
9. Select the desired memory cell using the arrow
keys.
10. Confirm the input with the OK key.
11. If necessary, select Back on the screen until
the Rivdom eVNG Main menu is displayed.
12. Navigate to Exit using the arrow keys.
13. Confirm the selection with the OK key.
The unlocked starting mask / working
»
mask appears on the screen.
The setting tool is ready for operation.
»
46 | English

4 Operation

DANGER
Live parts
Serious injuries or even death due
to electric shock
• If the insulation is defective,
switch off the power supply
immediately.
• Work on the electrical system
may only be carried out by a
qualified electrician.
• Keep moisture away from live
parts.
• Keep the system closed.
• Do not bypass or deactivate
fuses.
WARNING
Improper use
Death, serious injuries or material
damage
• Read and observe the
information in the operating
manual before operating the
machine.
• Store the operating manual in
the vicinity of the machine.
• Never use the machine in a
damaged condition.
• Use the machine only for its
intended purpose.
• Perform the work steps as
described in this manual.
• Never perform work on or
with the machine without a
workpiece.
• Do not make unauthorised
modifications to the machine.
WARNING
Parts flying out of the machine
Serious injuries or material damage
• Do not point the machine
towards persons.
• Disconnect the machine
from the power supply before
changing tools or accessories.
• Clamp the workpiece securely
before starting work.