Setting Values For Stroke; Assess Setting Result; Configure The Setting Tool / Change Settings; Overview Of Functions / Setting Options - Honsel Rivdom eVNG 2 Instrucciones De Uso

Fastener
material
Aluminium 5
Steel 7
Stainless steel 9
If the value selected from the table leads to a poor
setting result during the first setup, increase the
setting step by step with the values given below
until an optimum setting result is obtained.
Colour range for the
setting value
Light grey
White
Dark grey

3 .5 .3 .2 Setting values for stroke

The stroke values given are setting
values without units and do not
correspond to the actual stroke
executed in mm.
The same setting values for the
strokes apply for all fastener
materials.
Fastener diameter
1.5 2.0 2.5
Gradual adjustment for all stroke setting values:
0.1 to 0.2

3 .5 .3 .3 Assess setting result

See figure d, Assessment of setting result
No . Designation
1 Force / stroke value too low
2 Force / stroke value too high
3 Optimum force / stroke value
Fastener diameter
7 8 14 22 24 25
10 11 18 23 33 57
12 15 32 45 70 82
Gradual adjustment
0.1 to 0.2
0.2 to 0.5
0.5 to 1.0
3.5 4.5 5.5
3 .6 CONFIGURE THE SETTING TOOL /
CHANGE SETTINGS
3 .6 .1 Overview of functions / setting
options
Function
Riveting point
illumination
time
Standby time
Language
6.5
Counter
Warning
sounds
Key sounds
Factory
settings
Description / setting
options
Input of a time in
seconds
The set illumination
time is the number
of seconds for which
the riveting point
is illuminated after
pressing the trigger
or inserting the
battery.
Input of a time in
seconds
The standby time
indicates the number
of seconds after
which the display
goes dark.
• DE (=Deutsch)
• EN (=English)
• FR (=Français)
• IT (=Italiano)
• ES (=Español)
• PT (=Português)
• ON
• OFF
• Reset
The counter shows
how many fasteners
have been set since
switching on or
resetting the counter.
• ON
• OFF
• ON
• OFF
The setting tool can
be reset to the factory
settings.
For factory setting
values, see
chapter 2.13.
How?
Chapter
3.6.3
Chapter
3.6.3
Chapter
3.6.3
Chapter
3.6.3
Chapter
3.6.3
Chapter
3.6.3
Chapter
3.6.3
English | 43